X-surf 100 and BFG9060

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.

    I have X-surf 100 and BFG9060 in A4000. I am using Roadshow v1.14 and x-surf-100.device v1.16. When I have the BFG set to 50MHz the network works. As soon as I switch to 100MHz, my connection attempt fails.

    This sounds like the Zorro 3 bus is also overclocked if you switch to 100MHz on that design. Please make sure that the Z3 bus runs at 50MHz, otherwise any Z3 design will fail.


    If that accelerator can't stick to the standard, you always have the chance to downgrade the X-Surf-100 to Z2 (close the jumper), this should worl, albeit slower.


    Jens