I just received my ACA500Plus, to use on the following setup - PAL Amiga 500+, 1Mb Chip, high-end (5.5A on 5V) new power supply. ACA updated to latest firmware.
Have to say, a very impressive product, so much more than just an accelerator, the WB install is awesome, the profiles work great, etc. With that said, I have two issues, a small one and an annoying one:
#1 - when I first start the machine cold - the ACA display does the spin, then shows 00, then FF, screen goes dark blue, and nothing happens. Now if I reset with Ctrl-A-A, I get the menu, and everything works great. If I use it for a bit, I can turn off power and turn it back on, and the menu shows up.
#2 - the floppy drive, which works perfectly fine without ACA attached (tested over many reboots, with many disks), has a mind of it's own. On one boot, it will read all disks no issues. The very next boot, it might start throwing errors here and there, but a Retry fixes it. Then once in a while, it won't read any disk, until I reboot.
Any ideas?