I have an ACA500+ with an ACA1233n@40MHz installed in my Amiga500+ and I have a couple of questions:
1. What is the recommended why of installing Workbench 1.3 onto a CF card?
I ran the automatic installer from the main menu. Does this just install Workbench 3.1 or does it install 1.3 as well?
After the install finished, I rebooted the Amiga and selected the standard 1.3 configuration (F2) from the main menu but only a 1.3 Shell was shown not Workbench.
2. How are CF cards larger than 4GB supported? The product page indicates they are supported (https://icomp.de/shop-icomp/en…s/product/ACA500plus.html) but the wiki page for the automatic install recommends not using them. "The easiest way to setup a new system on a fresh CF card is to use a card not larger than 4GB:"
Thanks!