Hello! I love my Indivision ECS v2 (though I do have the ghosting problem, will try a different cable). However I have a small niggling issue.
On power up, the video mode goes into VGA 1400x1050, which is slightly upsetting as my display attempts to auto adjust (it has no manual adjustment facility) and loses the bottom 20 (estimated) pixels from the screen. The aspect is also wrong unless I force it into 4:3 mode.
Once I have booted from my Workbench installation and loaded the configuration tool, it automatically (without any poking) shifts into VGA 1920x1080 and the aspect is corrected, but this is only after a boot and loading the config tool. Which I'm not sure I can put into WBStartup since afaik it can't start ICONIFYied.
Is there a reason the 1920x1080 isn't being written to the settings in flash?
Thanks in advance,