Screws too short for use with any back plate

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.

    The standard back plate where such connectors are mounted in are between 0.75mm and 1mm thick. The screws in the DVI-I connector allow up to 1.5mm thickness for a back plate. That should be plenty. This may be different for plastic parts, especially if they are 3D-printed.

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.

    • :)
    • :(
    • ;)
    • :P
    • ^^
    • :D
    • ;(
    • X(
    • :*
    • :|
    • 8o
    • =O
    • <X
    • ||
    • :/
    • :S
    • X/
    • 8)
    • ?(
    • :huh:
    • :rolleyes:
    • :love:
    • 8|
    • :cursing:
    • :thumbdown:
    • :thumbup:
    • :sleeping:
    • :whistling:
    • :evil:
    • :saint:
    • <3