HI,
I've recently installed my Buddha Plus One and I'm unable to get the board visible in ESM or ShowConfig with my accelerator installed.
My system:
2000 rev 6.2
68030TK-02 in CPU slot adapter
GBAPII++
GVP HC+8 (Jumpered to 4mb)
ACE2B
Buddha
All other Zorro cards are functioning correctly so Buster doesn't seem to be at fault.
Ive Tried swapping the cards around and I've tried with just the Buddha, no difference.
Looking at the Buddha Plus One Registers (mostly above my understanding) I see mention of INT2. The CPU slot adapter has an INT2 header and I wondered if this needs connecting to something?
Buddha is detected and boots from DOM with a 68000 in the slot adapter. 68030Tk causing the issue, it does however work with the other two cards.
Is there anything I can do to make this work or should I accept that the two aren't going to play nice together and rethink my plans for the Buddha card? I have a rev 4.1 board which is a restoration in progress if needs be, I'll use it in that, but ideally the 6.2 system was going to be my enhanced system with modern solutions and the 4.1 a period piece, retiring regular use of the ageing SCSI HDD.
I haven't tried booting with the 68030 in the CPU socket as ACE2B is in the way and I don't really want to remove it unless its suggested to try this.
Thanks.