Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Please understand that you need to create an account to be able to post, guest posting was disabled as an anti spam measure.
Hi, I installed the ram in the card.
I turn on and make a black screen.
I tried to open jamper j303 on a2630. the system starts but does not see the ram.
I tried to add the ram with the command "bigram -addmem"
it does not work it does not see the ram
I think the ram card is bad. What should I do to replace it?
First of all, please make sure that the A2630 is not overclocked. BigRam 2630 requires the accelerator to be clocked at exactly 25MHz. Even the simple 28MHz-hack (which consists of one wire) is too much.
Thank you. Tomorrow check. I think the CPU is at 25mhz and the FPU at 28mhz. Can this be the problem?
Bus load may also be a problem, and FPU is such a load, but let's focus on dialing back any overclocking first. Anything else would be speculation.
my a2630 board has a 28.8Mhz oscillator. I bought now a 25Mhz oscillator. as soon as it arrives I try to replace it
thank you
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
