Hi!
I have an Indivision mk2 cr (red board) which was working perfectly so far. HDMI output. Until I downloaded the config tool to see what is available there. I didn't change any setting after it opened, there were a lot of things, and I didn't know what does what... But I pressed the "TEST" button to see whether it will test with some default settings. The result was: black screen... I waited a bit, pressed ESC, nothing happened. I restarted the Amiga and it didn't show any picture either. Just a black screen (I think no signal, not even the Indivision logo coming up). I don't have unfortunately any RGB-SCART cable. Is there any way to reset it? Why did the TEST button change the setting stored on the board? The Amiga loads up as normally, HDD lights flicker after a while it stops.