Hello, I'm working on a all-in-one case for my ACA500+/ACA1234/GOTEK based on an existing design for ACA500.
At the moment I have a prototype, still have to redesign it properly in Fusion360 and have it 3D-printed, but the general layout inside will remain as I have it now.
Its current state is visible in the picture attached.
There's now quite a lot of stuff inside the case and only a series of narrow ventilation holes towards the back (partially covered by a ribbon cable).
My question is: should I worry about the 68030's cooling? Should I add a heatsink at least, or it shouldn't cause any issues?
Cheers!