A604n clockport extension doesn't screw in under floppy drive bracket

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Please understand that you need to create an account to be able to post, guest posting was disabled as an anti spam measure.

  • Hi,

    I don't know if this is a problem with the A604n as such, but I can't get the clockport extender to sit under the floppy bracket. It's like the screw is too short - it just goes round and round in the hole. Without the extra height of the clockport extended, the floppy drive bracket screws in tightly. Do I need to find a longer screw, and can anyone point me in the direct of what the screw spec is (diameter, thread pitch etc)?

  • You should not need a longer screw - unless someone has inserted a shorter one before. Can you take a picture?

  • It's about 6mm.

    It seems to have original screws everywhere else but this poor A600 has had a hard life judging by the state of it.


  • That's a rather fine-threaded screw for going down into the bottom plastic. Are you sure you've got the right screw? This one seems to go into the drive, not down through the board.

  • I swapped it with one of the other case screws, which seems to work.


    I don't think Commodore had the best quality control when they built these things!

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.