Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
Just a followup for others.
The most obvious screw would be the mounting screw of the floppy drive that also holds the riser card.
That screw was too short to grip when I had both the floppy and the A604n riser card mounted so I instead used the PCB mount screw immediately to the left of the expansion port.
-
Thanks!
(Maybe that should be added to the wiki somewhere)
-
The documentation for Indivision ECS v2 states:
For installation in an A3000T, A1000 and A600, additional parts are required that are not included in the normal Indivision ECS V2 package. If you want to install the flickerfixer in one of these computers, please download the respective manual from our Wiki wiki.icomp.de.
However, I cannot find instructions these, except the relative sparse words about fitting an Indivision ECS on the
A604n page.
It's not rocket science but I have two questions that I think should be made clear on the wiki:
- Should the extra socket be used in-between the A604n and the Indivision?
- Should the grounding wire be used, and if so how should it be connected?