Hello,
I have the following issue after I stared using the CF controller on the ACA1234.
Steps I did to boot from the ACA1234
- Added a 256Gb card to a MicroSd->CF card and put it in the CF reader from the ACA1234
- removed the CF card from the internal IDE to prevent that I am going to crash it
- Rebooted and installed via ACA set the MicroSd so a 100 gig partition was created and mounted and a empty disk ( I did not install workbench)
- Rebooted and copied all workbench files to the empty disk from the ACA.
( on this moment the Amiga still mounted internal IDE and ACA drives)
- turned off use INTERNAL IDE via ACA tool to boot from ACA disk.
- The amiga boots from the ACA disk and uses my complete old workbench configuration
The strange thing is that I can't see my internal IDE/Disk anymore.
What can I do to prevent my Amiga to boot from the internal IDE when I check the USE INTERNAL ID box in the ACATOOL?
My best guess now is that the complete IDE controller is not active anymore because I unchecked it.
Thanks in advance and have a great weekend.
Best Pascal.