Is there any way to set the AGA Mk2cr to use native resolutions just scan doubled & flicker-fixed? Maybe limited to the analogue VGA lines? From the best I can determine the maximum actual video signal is roughly 1500x568 (PAL Super Hi-Res interlace) with the native screen modes (NTSC & PAL.) In the case of my machine, it is actually 1500x484 (NTSC.) Though, in theory, my system can operate in pseudo-PAL mode with a resolution of 1500x568, the clock crystal will still be NTSC though.
Since I cannot figure out how to set up scaling, which I prefer to avoid anyway, and I'll be attaching this to a CRT monitor (which should be able to handle those resolutions - according to the manual,) a native resolution mode would be appreciated. The only limitation of the monitor is that it cannot go below 30 Hz, so the scandoubler is a must.