Hi, I'm having some trouble getting readable characters when connecting to the remote control menu.
I have a reloaded MK2 board and purchased the power supply from icomp. I've tried using tera term on windows 10, minicom via Unbuntu 20 and serial via MacOS and they all have the same issue with junk characters being displayed. It is worth noting that windows and linux were run in a virtual machine. After trying to connect many times across all of the platforms, I have only ever been able to connection twice. One time via minicom with a CPU installed, and another time with tera term (Screenshots attached) with no chips installed. On the Windows side, I connected successfully, turned off the MK2, inserted my chips and turned it back on to bad characters again (Screenshot Attached). On the linux side I was able to successfully transfer JiffyDos.
On a side note, I have not be able to get the firmware to successfully run either although I don't know that it should.
I am able to get a commodore screen to boot and show however the D46 light is flashing when I have all of the chips inserted. Any thoughts on getting a consistent connection to the remote control menu?