Hi,
Is the pinout on the 20 pin IDC 2.0 pitch the same on Indivison MK3 as MK2cr?
Thanks in advance
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Hi,
Is the pinout on the 20 pin IDC 2.0 pitch the same on Indivison MK3 as MK2cr?
Thanks in advance
Is the pinout on the 20 pin IDC 2.0 pitch the same on Indivison MK3 as MK2cr?
No, because it's 22-pin on the MK3
Oh crap Well, to the drawing table then for me. Is it possible to get the pinout? It will be for an adapter when using the Ratte Auto Monitor Switch.
It may already be in the Wiki - at least I meant to publish it there. Please check (only shortly in the office now, CAD system is switched off).
Wonderful I will wait for it and then make a suitable adapter to use with the monitor switch.
It was already in this forum (a German customer asked for the pinout when the product was just released), but not in the Wiki. I have added it to the hacking page now.
DAC0 to DAC2 are the analogue outputs. DAC stands for Digital to Analogue Converter.
Is there any information covering the DAC0-2 mapping to R/G/B signal?
Is there any information covering the DAC0-2 mapping to R/G/B signal?
Just in ascending order:
DAC0 = red
DAC1 = green
DAC2 = blue
Lovely! Thanks a lot Jens
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.