Posts by steenlund

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.

    I am a developer myself and I wouldn’t mind volunteering my time to help.


    Writing a grex.board driver does not seem too difficult, problem is the chip drivers. I have been looking at the xfree source for the radeon rv100 but I am unfamiliar with the code so it is taking some time :)


    Let me know if there is anything I could do to help.


    Cheers

    Steen

    Hi,


    I was looking through the P96 SDK and noticed that GRex is defined as a BoardType. Is GRex actually supported and if so which graphics card is supported?


    I would love to get rid of Cybergraphics.


    Cheers

    Steen

    An original daughterboard has arrived and I have replaced the GRex4000.


    I had to pull the XSurf out just 1mm or so but then it worked in the original daughterboard.


    Still no luck getting it to work in the GRex, even when pulled a tiny bit out of the socket. I will have to do some measuring to see if everything is correct on the GRex, I have a feeling it might the auto config lanes on the PCB that are faulty. This is going to take some time to debug.


    Thanks

    Yes, that was the first thing I tried but still no luck.


    I just wanted to know if there were any known issues as I don't have any other Zorro boards to test with nor do I have a original daughterboard, but I am working on getting my hands on some. Then I can figure out if it is my Amiga, a bad Buster, or the GRex

    Hi,


    Any one have experience using the XSurf-100 in a GRex? The card does not show up in the boot menu or Show config at all and I am wondering what could be wrong?


    I am working on getting my hands on an original A4000D daughterboard to test further.


    Cheers

    Steen