Never mind on this issue, was able to get it working again. Should I perform a backup just in case of future issues? Or not necessary?
Posts by Pickejuice
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
-
I have performed the upgrade to the Buddha. Was a bit worried because the DOM could not be seen by the system but now It does. Also it now recognizes “some” CF cards but I’m sure it’s just the ones I have., might have to reformat with HDtoolbox or something similar because 2 out of 3 are recognized. Also, my Zip drive is still recognized by the system so I’m really happy.
Again thanks for a fine product.
-
Thank you for your reply. Since the PC and Amiga are not too far from each other, I will try to get working Amiga Explorer for the mean time to transfer files and look into networking for later, but both of my zips are recognized, mounted on the amiga, and working fine at the moment.
How about access to them "CF's" issue?
-
As in the documentation, ensure the black and red cable go to the top 2 pins on the Buddha HD activity pins with the Red cable in the center of the 3 pins.
-
Inserted the install Dom on port 2 and ensured the jumper was installed but when applying power, the computer does not recognize the Dom. Does not even show in the initial boot list.
The card still recognizes hard drives and the install zip drive. I even made a bootable zip disk and it works. Do I have to reflash the card, or replace the Dom?
