Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
I have installed my Indivision AGA and it seems to working with no problem for the normal resolutions. I've installed the HighGFX driver and tried the 1024x768 mode and almost immediately I get screen corruption/flickering, etc. reverting back to a lower screen resolution makes the problem go away again.
I haven't added a heatsink to the Alice chip yet, but I'm fairly sure the A1200 wasn't powered on for long before I tried this so it didn't have chance to get too hot. I was wondering what the other fixes might be? My A1200 is a rev 1B board if that helps.
-
Thanks for the DeLock clue, I had a look on their website and found https://www.delock.de/produkte/S_83119/merkmale.html which looks like the part I have but doesn't give much detail, however I also found https://www.delock.de/produkte/S_82976/merkmale.html which is the USB 3.0 version with more pins but physically looks the same and the data sheet measurements seem to match, including that the screws are #4-40 UNC. The threads on mine I think are 3/16" long so I just need to find the next length up, either 1/4" or 5/16" should be enough extra thread.
Normally I would agree with you about the case, however I got one of the new A1200 kickstarter cases as my old case was broken and very yellow and this has optional cutouts for the USB ports just to the right of the trapdoor and this double USB lines up perfectly with the holes.
-
I've attached photos of the screw/bolt (whatever you want to call it) and the USB part. It looks like there's a nut captive in the plastic moulding, you can see the thread in there.
So yes, I just want a longer screw/bolt, but what sort?
-
I have a RapidRoad with the double USB adapter and I've come to mount it in the A1200 case and found the bolts aren't long enough to go through the case plastic and reach the captive nuts on the adapter. I've gone through my collection of miscellaneous nuts & bolts and I can find some that have the right thread but they're the same length so still too short to work.
Is it possible you can tell me what size/pitch the bolts are so I can find some with a longer thread?
