Ok, thank you
Posts by RedFoxtrot
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
-
is there anything else I could try?
-
Now with the IndiECSv2 installed:
Black screen on both Scart and VGA when A500 turned on.
Insert rescue disk and it boots/loads
Wait 7 seconds for it to load flash file - black screen.
Blindly type flashtool flash firmware - df0: drive cycles for a while then stops - black screen.
-
-
Sorry for the misunderstanding, The Amiga 500 works normally with the original Denise chip in situ and boots other floppies. I can boot up workbench, demos, games etc but when I put the rescue floppy into the drive it does not recognise the disk.
-
Hi
I have tried to run the rescue floppy on my Amiga 500 but it does not boot from floppy. It does however boot from my Amiga 1200
Any ideas?
-
Hi
I have been enjoying the Indivision ECS V2 for a month now. This morning I switched on my amiga 500 (rev6a) KS1.3 to discover a black screen. I can insert a game in the disk drive and it loads & plays the game music. I tried a scart cable through the RGB video port and it displayed the games graphics. I have also tried reseating the ECS V2 but still get a black screen.
Please help
Robert