Well interesting progress. The Master/Slave really had no difference. What I did try different was to when I got to 3.1 ROM screen just did 3 finger reset. And it booted. So from a a cold start its not seeing the device but a reset it works. My hardware combination in the 2k is a bit odd. I have a :
6.2 Board
Indivision ECS
GVP Geforce 68030 @50MHZ 8 megs of fast ram, No Drive. Have not disabled SCSI
Buddha,' 4G Industrial DOM
A2091 no drive, disabled boot just using the 2 megs of ram.
Supra ram card for additional 2 megs.
Matze Graphics Card
Multface III for high speed serial port. Need to get network card
HxC Floppy emulator
I had a A2630 and the Bigram2630 but via email with you just could not get someone to program it in USA and too expensive to just ship back and forth be cheaper to just buy it again.
Tried pulling everything but the the GVP and Buddha not difference. Its like the DOM is just really slow to initialize. I checked the config options in flash and see that MAXWAIT is set to 255 so I suspect that is the 30seconds as cold bold takes about 30 seconds to fail.
Hopefully information helps. Looking to the add the 2Meg ACE I see in store but starting to think I am pushing luck on what I can get in to an A2k.
Thanks for help
Doug