Can you send my Unit back to me and I will try to get the power supply sorted.
Posts by daver999999999
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
-
It seems the Ca Power unit is out of stock for 110 Volts. Otherwise I would order one. I can't put the unit back in the original case because I was stupid and threw it out. I may try to source a replacement one.
-
I am in the process of replacing the HDD with a CF card as we speak. Just Haven't completed it yet. The tower might be 20 years old but I didn't think it was. the time passes quickly. So what do you suggest for Powering the unit.? I am more than willing to replace it if necessary. It does look like some kind of Nail on the connector.
-
Power supply is an internal 235 watt that came with the Power Tower that the Motherboard is installed in. It has a Gotek Drive connected. And the included HDD that came with the amiga 1200. There are no other peripherals. Also sorry about the late reply as I am not getting notified when you post.
-
OK do I have the same options? Refund?
-
Could you tell by the warranty ID NT&JE
-
Have you received mine yet?
-
I cleaned with IPA and Deoxit. I saw no Oxidation on any of the pins before or after cleaning. There is still no signal to the HDMI. Attached are the pictures of my Lisa.
-
-
So you are saying I need to edit the photographs so I can upload them? So I need to learn to use photo editing software in order to get a warranty replacement? The Board doesn't work. I would like it replaced. Is that not good enough?
-
I looked over the board. I don't see anything. I used a Soldering Microscope that I have some pics I took with my phone. The system will not allow me to upload them It says they are too big.
-
NT&JE
Ottawa, IL USA
-
Yes it is completely tight against the board. i am sure it is completely seated.
-
My MK3 1200 is not working at all. I just bought it. I am sure it is connected properly. Machine boots up normally with composite cable but VGA and HDMI Do not work at all.
Can you please help me?