Has there been an update on testing with the last set of changes recommended by Jens? Would love to get this resolved on my board.
Thanks!
Neil
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Has there been an update on testing with the last set of changes recommended by Jens? Would love to get this resolved on my board.
Thanks!
Neil
Just a comment… So good to see action on this! Thanks for working on it!
Jens,
I have just sent the information you requested in an email. Sorry for the delay, I've been busy between the holidays and work.
You recently asked if any of us has an oscilloscope. Unfortunately, I do not.
Thanks,
Neil
Jens - Where can I find your email address?
Jens - I’d be happy to test the Commodore power supply with my Reloaded MK2. What do you need from me?
Jens - I am still experiencing the issue as described in this thread. Do you still need a unit to review?
I, however, am still experiencing this with two different VIC-II chips. I am willing to send everything over (case, C64R with chips, power supply) and even a LCD TV if it will help. Please let me know.
Jens - Have you had any luck in reproducing this issue?
Jens - Should I send an email to you regarding the NTSC issue I’m experiencing? I want to be sure to be in the know if/when a resolution is found.
Thanks,
Neil
Kinshi - I have the same issue with my 6567R8 not being detected. Moved to a 6567R9 and that issue went away.
I've been in e-mail contact with at least one person in august, and this has not been forgotten (tomxp411, that might have been you). I yet have to reproduce the problem here, as I currently believe it to be an edge case that can be fixed with a singla resistor value change.
I confirm that cases like this will be handled under warranty.
Jens
Jens - Should I reach out to you via email for this?
I'm experiencing a problem with my C64R MK2 board, which is only a couple months old at this point. After the unit is powered on for an extended amount of time and allowed to get warm, the Sharp LCD TV I have attached to switches PAL mode, and the picture goes off center and mostly monochrome. I have a VIC-II 6567R9 installed. I have heat sinks from Ray Carlsen on the VIC-II (6567R9), SID (6582) and CPU (6510). I've tried another VIC-II (6567R8) that experiences the same thing, and I've got another version (8562) on the way from eBay, but I anticipate the same issue with it as well. If I turn off the unit and allow it to cool for only a short time, the picture returns to normal.
Everything is housed in a new C64C case that I received this week. It was happening in a bread bin case, and it's still happening in the C64C case.
Any assistance with this would be greatly appreciated! I'm very excited about owning this board since I only just recently purchased it. However, it is a bit disappointing to see the screen change into something that isn't right.
Regards,
Neil Forker