Running a BBS on the TC in standalone using RRNET

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.
  • We were asked a very good question over at the TC FB-group. We know that we can use RRNET in our TC in standalone mode and "call" BBS'es

    using CCGMS/Strike terminal programs which support RRNET so that it translates into Hayes AT command.


    BUT...how about the other way around ? When the TC is in standalone mode and we connect it to ethernet via RRNET, how would it be possible to

    run a BBS on the TC in standalone mode ? The only way I can think of is to have a version of the BBS.software which support using RRNET

    instead of RS232 modems.


    QUESTION: Does someone know which BBS software (please note: the BBS software which runs the BBS itself -- the "server" side if you like) that

    can operate and accept telnet-calls over the RRNET ? Maybe a RRNET-patchet versions of existing BBS-systems ?



    Espen

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.