So a few questions.
So I use BenQ BL 702A and BL 912 LED screens for my TC64 V2 setups. I use them in cartridge mode. I have resolution set to 800x600, 50Hz and synced to VIC II. They work fine with smooth scrolling. So question about the scanline settings. There are 4 options. No scanlines, 25%, 50% or 75% scanlines. So what does the percentage numbers mean? I find 75% tend to give more washed out colours. 50% gives okay colours and 25% gives the most vibrant colours. However, 25% seems to give the most intense scanline effect then 50% and then 75% seems to give less intense scanlines. Why does 75% give washed out colours but going more intense scanlines intensity gives more vibrant colours?
Also I read somewhere that using LCD screens on the TC64/TC64 V2 gives some ghosting which will not happen if a CRT is used on the VGA output. I have quite a bit of ghosting on the above mentioned screens. And yes, I have tried out various high quality VGA cables. Same results no matter what VGA cable I use. So is there any explanation for this ghosting and can anything be done in a future firmware?