INDIVISION AGA PROBLEM
- ritzu
- Thread is Unresolved
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
-
-
What kind of powersupply are you using?
-
-
Ok, that should do the trick. That it works after some minutes of "warm up" does actually hint the problem being connected to temperature.... first please make sure the indivision sits really tight on the Lisa IC (apply some gentle force).
-
Further, there may be more fixes required if you're running higher-resolution screen modes. Most of the "flickering" effects that you see aren't caused by Indivision, but they are merely made visible by Indivision. The root cause is that the AGA chipset wasn't fully tested by Commodore before it was released (mostly due to lack of monitors that can display all the modes).
Please specify:
- what version of Indivision you actually have (it's not 100% clear from your description)
- what version is the Lisa chip on your main board (take a picture if you're not sure how to identify the manufacturer HP, Commodore or VLSI).
- what's the exact screenmode you are running
-
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.