Is it possible to increase the maximum pixel clock of the ECS V2? I would like to try to make a WUXGA 1920x1200 @60Hz to match my Benq G2400 monitors panel, but that requires a pixel clock of about 192Mhz, and it seems like the max is around 165Mhz
ECS V2 - Max pixel clock
- durniplot
- Thread is Unresolved
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
No, the hardware does not support such a high pixel clock. Memory throughput may be barely enough for that, but the FPGA family is not suited for that speed.
-
Fair enough. I'll use a smaller panel.
-
You could also try to half the resolution of your Panel. I have a 1600x1200 Monitor and with a resolution of 800x600 and I can‘t spot any scaling artifacts/interpolation added by the monitor.
-
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
