Hi,
I have here TWO Buddha Flash phoenix edition - original both with factory 2nd.scsi.device 103.16 and buddha_atapi.device 120.4 (3.6.2000)
Here works ALL OK.
After flash with new 52.101 works one Buddha (flash IC CSI) OK (buddhascsi.device 52.101 in system) with IDE HDD BUT second Buddha (flash IC Samsung) NO - no visible any buddhascsi.device 52.101 in system. (HDD is of course 100% connected on IDE)
I know buddhascsi.device 52.101 has "sleep" (not visible in system) when no any device on IDE port BUT have really problem with connected HDD on IDE port then here no problem or exists "bad detection" in latest 52.101 ?
I have test with programmer (check Samsung eprom) and after flash (flashing in Amiga) is eprom OK - verification flash 52.101 file is in eprom ok.
After re-flash with programmer back on old original 103.16 works too this second Buddha again OK.
Test with same IDE cable and too HDD, same system and same A4000D
Where is problem please at second Buddha Flash together with latest flash 52.101? (buddhascsi.device 52.101 not visible in system, Buddha as hw in system - ShowConfig or Buddha flashing tool/sw OK)
Thanks.
Regards, Sveta