As the title says, I have an Amiga 500 Rev 6a with ACE-2 2MB chip, with the new ACA500plus and ACA1233n connected to it. The RTC Module is properly installed on the ACA1233n, and in the ACA500plus boot menu, I have selected A1200 Accel both in the Global F8 menu and the local F10 profile menu. Still, when the computer is first powered on, the module is not seen, and when Workbench 3.1.4 boots up, I can go in the Time Prefs and set the time properly and save, and then when I reset the ACA500plus the RTC shows the module installed.
I have tried the Global and Autodetect settings, but these don't seem to work at all.
Any ideas?
Thanks