Keyrah2 and power light

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.

    Is there any way of having the Amiga 1200 power light be on without changing the keymapping when using the Keyrah2?

    This will take circuit modification - the Power LED is hard-wired on Keyrah V2. I don't have the schematics with me, but I can take a look next week when I'm back from holidays. Just give this thread another bump on Tuesday or Wednesday.


    Jens

    U4 is a schmitt trigger-inverter 74xx14, which handles the delay circuit and LED drivers. There is one unused inverter on that chip, pin#13 being the input and pin#12 the output.


    The power LED is handled with the inverter on pin#5 (input) and pin#6 (output). Cut the trace coming out of pin#6, then make a wire connection from pin#6 to pin#13 of that same chip. The new, inverted power LED signal is then on pin#12, which you can route to the outermost pin of the A1200 LED connector (the one closest to the edge).


    Jens