Indivision ECS V3 - low profile pins for A600

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.

    Hi!


    I'm actually experiencing the same issue as there:

    Indivision ECS V3 - mounting problem in A600


    The actual pins (male-male) to connect inside the A600 / extension card is a little bit to high. And so, the keyboard is mechanically pushing the chip ram extension (with pin and Indivision) down.


    I would be glad to have lower/smaller male/male adaptor to fix that and be able to close the computer properly.


    Would it be possible to provide such a thing?


    Thanks!

    Cheers

    Can you share the order number(s) that you've purchased the Indivision and A604n with?


    Jens

    Sure.


    A604n:

    • Well, it's the "copy" from Archi Tech. To my apologize, as I restarted the Amigas. I was not aware of the A604n
    • Got if from a reseller


    Indivision ECS v3:

    • Bestellung 132176

    Thanks - I'll send you the invoice when I'm back from holidays. This is not a normal product in the shop, as you may have noticed :-)


    Jens

    Thanks !


    Warning you are tempting me to order something else to cover the shipping cost 😁


    Enjoy your holidays.

    I can see an open shopping cart in your account that you didn't push to checkout - judging from the number, it must have been a month or two after your Indivision purchase :-)


    Jens

    Well, I am always hesitating between the A600 and A1200 ).


    Looking forward the low profile pins. There has been some progress on the A600 side. OS 3.2 boots !


    Cheers

    Nicolas

    New invoice sent - and please ignore whatever the shop system has just sent out, that's just a wrong click on my side.


    Jens

    Hi !


    first, I know I should have buy the original, A604n...


    Now, that I am using the "copy", I noticed, it's not possible to fit the Indivision onto the Chip RAM expansion board because of the 6 pins (3x2) in the middle of the socket. There are quite tall and enter in conflict with the board when using the low profile pins. See pictures.


    Having a look on the A604n, it looks to be the same.

    http://wiki.icomp.de/wiki/File:A604n_installed.jpg


    How to get the stuff fitted using the low-profile pins for the ECS v3 ? Is it "allowed" to get them ?


    Final goal: closed the A600 ! finish the project !

    Cheers

    That must be a mistake by my staff: The blue units were equipped with too-long pins and are meant to be cut to the same length as the 48 Denise-pins. Sorry about that - if you cut the alignment pins with a wire cutter to be the same length as the low-profile pins (which you already have), this should fit also in the rip-off of the A604n.


    Jens

    Ok.


    I will do that after the vacation at my IT-Job place. They should have a nice (better) cutter as here at home


    Thanks for your support. Very appreciated.


    PS: I'm impressed by the power supply. Small, cute, works great.


    Cheers