EDID BenQ BL702A

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.
  • A1200 Rev2B OS 3.2| SanDisk CF64GB | Blizzard 1230 IV 64MB FPU 68882/50 | Indivision AGA MK3 | CA-PSU | Eizo S1933 | Bose Companion 2 series III

    A500 Rev6A OS 3.2| SanDisk CF16GB | ACA500+ V2 / Blizzard 1230 IV 32MB | Indivision ECS V3 | ACE2b | CA-PSU | Eizo S1933 | Bose Companion 2 series III

    A1200 Rev2B OS3.2.2 | Black Edition | SanDisk MSD32GB | PistormLite32 | Indivision AGA MK3 | RTG Picaso96 1280x1024| CA-PSU | Eizo S1933

    iAmiga 27" | OS 3.2 FS-UAE | SDD 1 TB | RTG Picaso96 2560x1440

  • Did some tweaking and ended up with a nice and "close to 50Hz" 5:4 profile for my BenQ BL702A. It fills the screen fully and pixels are OK-squarish without using either H or VFilter.


    Profile is tested with several demos and games with good result :)


    I have attached the setup in this post.


    Enjoy!

  • ClaesB

    Try the "Darken" in the adjustments for that "retro-feeling scanlines"

    I think I use about 15% with my Eizo monitor.

    A1200 Rev2B OS 3.2| SanDisk CF64GB | Blizzard 1230 IV 64MB FPU 68882/50 | Indivision AGA MK3 | CA-PSU | Eizo S1933 | Bose Companion 2 series III

    A500 Rev6A OS 3.2| SanDisk CF16GB | ACA500+ V2 / Blizzard 1230 IV 32MB | Indivision ECS V3 | ACE2b | CA-PSU | Eizo S1933 | Bose Companion 2 series III

    A1200 Rev2B OS3.2.2 | Black Edition | SanDisk MSD32GB | PistormLite32 | Indivision AGA MK3 | RTG Picaso96 1280x1024| CA-PSU | Eizo S1933

    iAmiga 27" | OS 3.2 FS-UAE | SDD 1 TB | RTG Picaso96 2560x1440

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.