I have read the Wiki and instructions, but I cannot find the answer to how I get keyboard support and sound on MK3 CD32?
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
-
Sound is a matter of a config tool setting.
Keyboard requires soldering - and I didn't have the time (yet) to look for easy-to-identify solder spots for the required signals.
-
In an other thread you wrote: “For accurate audio filter reproduction on HDMI TVs, a fourth solder connection must be made.”
What does this mean? Will the audio sound wrong? Will there be audio?
-
What does this mean? Will the audio sound wrong? Will there be audio?
There will be audio. THe "additional soldering" is for the LED signal - you may know that this switches the low-pass filters on and off, and without the additional connection, this switching possibility would be lost, and the filter would always be off. Some people may actually prefer this, but it would just not be 100% accurate.
-
Dear Jens,
I have read the manual too, but i can't find on the wiki an accurate image of the soldering point.
Could you give me more information about? Or just an hi-res image is enough.
Thank you
-
-
Thank you Mad2er0
-
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.