how much would repair cost?
broken pin on indivison ecs v2
- uigiflip
- Thread is Unresolved
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
-
If you're fine witha single-pin-replacement (that is: The insulator will be cut open on that spot to remove/replace the broken pin), we can do that for a flat 20,- EUR plus tax and shipping. THe unit should work without that pin, just the colours on the 23-pin RGB port will be "off by a bit" (literally - bit#1 of the blue channel), but colours on the VGA output will be OK. If you only use the VGA output, you might just leave it like this.
-
Isn’t that just a socket you could simply swap out?
-
Isn’t that just a socket you could simply swap out?
That adapter socket (male on both ends) is soldered in, and it's a 4-layer PCB with components on both sides. During production, this is done with a selective-soldering robot, but in service, it's all manual labour. You can pay a technician to do that exchange, but with roughly 1 hour of work and 85 EUR/hour for the technician, you easily end up at a price where you can buy a new unit - that's not what the customer asked for.
I guess the most important bit of information is that there is no danger operating the unit in it's current state.
-
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
