After being out of the Amiga world for a long time, I finally acquired an A1200 in pretty decent shape (case yellowed, but in good shape otherwise) and it works as it should. I also acquired an ACA-1233n (I believe it is a -40), code gT3fb. I went to put this in my system and... nothing. The power light comes on but nothing else happens. I tried cleaning the expansion port card edge with a little Deoxit. It didn't help.
So I did a little reading around and found where the Xilinx might fail and to measure the output of the 3.3V regulator. A good solid 3.3V DC. The chips on the board are barely even warm. Also checked the power rails (5V, +12V, -12V) and they were all right on.
So I am assuming there is something wrong with the card, and I do not have another machine to test it on - So it will have to be sent for repair... or is there anything else I can check before packing it up and sending it across the world?
Also, since this device doesn't have the FPU on it, is it possible to have this added if I do have to send it back?