ACE2B + A2630 + A2091 + Buddha IDE

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.
  • Hello,

    I have installed the new ACE2B on My A2000 Rev 6. All ok I see 2Mb chip

    My A2091 with rom7 now (also without BuddhaIDE) takes 30 seconds before regular boot from scsi hard drive. Even turning off the amiga and entering the early startup always takes 30 seconds.

    Am I wrong something?

    The hard disk has the termination jumper and has ID Zero.

  • This may be caused by the SCSI timeout and missing last-disk bit set in the RDB of the SCSI harddisk. This has nothing to do with the Buddha or any of our hardware - it's a setting you can correct using HDToolbox: Launch HDToolbox, check if the highest unit number is listed as "changed" - if so, click "save changes to drive" for that last disk. This should get rid of the power-up wait.