aca1233n - problem with acaswitchcpu in A1200

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.
  • I am trying the acaswitchcpu command. When run without any arguments, it reboots fine into the CF card with the host CPU 68020.


    But when given the command 'nm' (acacpuswitch nm) , the computer tries to reboot but gets stuck at the very beginning, black screen. The only way out is a cold reset.


    The aca1233n is bone stock without any mod but an RTC module installed on the MB clockport.


    Any ideas?

  • Switching back to 68030 requires a power cycle - that's a weakness of the hardware. It was planned to make it fully switchable, but there is no data path for the 68ec020 to reach the required registers of the accelerator.

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.