Using my CA-PSU on an A600 with a 40mhz Furia. I've had no issues with the PSU and having the switch within reach is very convenient. While I was tracing a keyboard issue I measured 4.90V at the floppy connector. Is this within spec for this PSU? I thought it would keep the 5V rail nearer to 5V. Perhaps my meter is not calibrated or something.
CA-PSU voltage reading
Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.
Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.
Don't Panic. Please wash hands.
-
4.9V sounds indeed a bit low (should be at least 4.95V), but if you intend to do measurements at the "less than 1%"-level, I'm asking for the calibration protocol of your volt meter first.
Further, the A600 is a dual-layer baord, so further voltage drop is happening between the input filter and the floppy power connector.
My expectation is that you get a much lower reading with a different PSU.
-
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
