I am really sorry to dredge this back up again , but I cannot get my ACATool to load kickstart 3.1.4.
So I have Classic Workbench 3.1 installed on my CF HD, I use the maprom feature normally and without issue on ACATool. When I try and map to kickstart 3.1.4 it simply will not work. I am unsure that when I map this rom do I need to remove my CF HD with 3.1 on it?
What I experience is usually this:
I use ACATool 2.4 to map to kickstart 3.1.4.
I then soft reset my Amiga
After a few seconds of a black screen my Amiga will eventually revert back to the installed chip roms for kickstart 3.1 and that leaves me at that screen prompting to insert a floppy disk.
What am I doing wrong? It is probably my lack of knowledge so I was just wondering if you had some advice?
BTW the 3.1.4 rom files are exactly 524288 bytes so I don't think there is anything wrong with my kickstart rom file. Also it works in WINUAE and give me the correct kickstart screen for 3.1.4.