A604n clockport extension doesn't screw in under floppy drive bracket

Caution: Non registered users only see threads and messages in the currently selected language, which is determined by their browser. Please create an account and log in to see all content by default. This is a limitation of the forum software.


Also users that are not logged in can not create new threads. This is a, unfortunately needed, counter measure against spam. Please create an account and log in to start new threads.

Don't Panic. Please wash hands.
  • Hi,

    I don't know if this is a problem with the A604n as such, but I can't get the clockport extender to sit under the floppy bracket. It's like the screw is too short - it just goes round and round in the hole. Without the extra height of the clockport extended, the floppy drive bracket screws in tightly. Do I need to find a longer screw, and can anyone point me in the direct of what the screw spec is (diameter, thread pitch etc)?

  • That's a rather fine-threaded screw for going down into the bottom plastic. Are you sure you've got the right screw? This one seems to go into the drive, not down through the board.

  • The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.